ORTEC
ORTEC is an industry leader in the design and manufacture of ionizing radiation detectors, nuclear instrumentation, analysis software, and integrated systems.
- 865-482-4411
- 865-483-0396
- ortec.info@ametek.com
- 801 South Illinois Avenue
Oak Ridge, TN 37830
United States
-
product
Multichannel Analyzers
Multichannel Analyzers (MCAs) are workhorse instruments in many scientific measurements. An MCA analyzes a stream of voltage pulses and sorts them into a histogram, or “spectrum” of number of events, versus pulse-height, which may often relate to energy or time of arrival. The stored spectrum may then be displayed and analyzed.
-
product
Preamplifiers
The primary function of a preamplifier is to extract the signal from the detector without significantly degrading the intrinsic signal-to noise ratio. Three basic types of preamplifiers are available: the current-sensitive preamplifier, the parasitic-capacitance preamplifier, and the charge-sensitive preamplifier. ORTEC manufactures a preamplifier to fit your detector, your application, and your budget.
-
product
Delays And Gates
Delays, Gate and Delay Generators, Logic Modules, and Linear Gates are used in many research or teaching experiments and in non-research applications such as actively shielded spectroscopy systems. Delay modules allow the alignment in time of signals from different paths, so that a logical decision can be made within a logic module which will often result in an electronic go/no-go decision as to whether a particular detector analog output will be processed within an associated multichannel analyzer.
-
product
Compton Suppression Counting Systems
Compton-Suppression Systems are used to reduce the background continuum for low-background counting, thus improving the Minimum Detectable Activity and overall spectrum quality – particularly for small volume samples such as air filters and petri dishes.
-
product
Mobile Assay System
ISO-CART-85
Complete In-situ NDA Gamma-Ray Analysis Solutions for a Wide Variety of Samples including "Free-Release" Decommissioning WasteMeasures all common geometries: pipes, cylinders, floors, ceilings, walls, drums, boxes, and soilsEasy-roll cart for maneuvering over any surfaceWide selection of collimators and shields available for different measurement situationsContinuous height adjustment and variable tilt adjustmentISOTOPIC software, proven results on thousands of real-world samplesFactory pre-calibrated or calibrate with a single inexpensive mixed isotope point sourceFlexible reporting: measurement results can be reported in grams or activity (Bq or Ci)
-
product
Alpha/Beta Counters
ORTEC offers a full suite of MANUAL alpha/beta counters incorporating either gas-flow proportional detector or dual-phosphor scintillation detector technologies. These manual, single detector systems are ideally suited for applications requiring long count times for a small number of samples.
-
product
Gross Gamma Screening System
The Gross Gamma Screening system is intended for the rapid screening of urine samples for the presence of elevated radioactivity in a post-radiological event scenario. This system allows up to eight urine samples to be counted simultaneously in discretely shielded 3” x 3” NaI Well radiation detectors to quickly identify elevated radioactivity from personnel in the exposed population. This screening process provides critical information to Emergency Response Agencies and is accomplished with minimal operator training.
-
product
Food Monitoring Systems
Is a system of repeated examination, measurement and evaluation of levels of undesirable substances, such as plant protection products, heavy metals and other contaminants, in and on food.
-
product
Gamma Spectroscopy
Gamma spectroscopy is the science (or art) of identification and/or quantification of radionuclides by analysis of the gamma-ray energy spectrum produced in a gamma-ray spectrometer.
-
product
Alpha Spectroscopy
Alpha spectroscopy is used to identify and quantify radionuclides based on the alpha particles emitted in the decay process. Similar to Gamma Spectroscopy, energy spectra are generated with high precision detectors and electronics and analyzed with special software. Typically, samples are measured following chemical separation to isolate the radionuclides of concern due to the complexity associated with correcting for these interferences with spectrum analysis software as is common for many Gamma Spectroscopy measurements.
-
product
Fast Timing Discriminators
Fast timing discriminators enable the counting of narrow pulses at very high counting rates, and/or precisely marking the arrival time of these same pulses. They are designed to achieve the best time resolution and the highest counting rates by operating on the fast-rising detector signal.
-
product
Chemical Weapons Identification Systems
Portable Isotopic Neutron Spectroscopy (PINS) Systems have been deployed world-wide; increasingly, being deployed as part of national counter-terrorist efforts. PINS provides a non-contact and non-destructive means of identifying the CHEMICAL contents of "suspect" packages.
-
product
Photomultiplier Tube (PMT) Bases
Scintillation detectors produce light as they absorb energy, and these light flashes result in the release of a proportionate number of photoelectrons at the cathode of a photomultiplier tube (PMT). Each of the ORTEC Photomultiplier Tube Bases is designed to accommodate a particular type of PMT to distribute the operating voltages to all its elements, and to derive signals from it.
-
product
Electronic Instruments
The ORTEC range of modular electronics includes instruments in NIM formats as well as other modular instruments, such as photomultiplier bases, preamplifiers and other accessories. ORTEC also offers modular instruments for pulse height spectroscopy, fast timing, counting, high voltage power supplies and other special functions.