Filter Results By:
Products
Applications
Manufacturers
-
product
Clamp-On ATEX Ultrasonic Flowmeter
KATflow 170
The flowmeter is intended for permanent operation in Zone 1 and 2 hazardous areas and is an economical choice for a variety of metering applications. The KATflow 170 demonstrates that even the most complex technical requirements can be met with straightforward solutions.
-
product
Clamp-On Ultrasonic Flow Monitor
KATflow 10
The KATflow 10 is a simple ultrasonic clamp-on flow monitor, which provides an extremely cost-effective alternative to in-line flowmeters on effluent, wastewater and sludge applications. The KATflow 10 is used to monitor the flow of liquids containing higher levels of solids or entrained gas bubbles for measurements where a general flow indication is sufficient. The instrument is extremely simple to install and commission and is ideal for applications which demand good repeatability and reliable results.
-
product
Coriolis Mass Flowmeters
CMF
Applicable Fluids: Gases Slurries Liquids. Typical Applications: Custody transfer Reactor feed ratio Density measurement Batch control.
-
product
Dike-Type And Partial Flume-Type Flowmeter
These flowmeters provide the means for flow measurement and flow control of open conduit channels in water supply facilities and sewage facilities.
-
product
Direct Reading Glass Flowmeter
Series DR
5 mm and 150 mm, ±5% FS Accuracy, Interchangeable Flowtubes
-
product
Fixed Clamp-on Flowmeter
D116
Gentos Measurement & Control Co.
D116 Series Ultrasonic Flowmeter is a state-of-the-art universal transit-time flowmeter designed using FPGA chip and low-voltage broadband pulse transmission.
-
product
Flowmeters for Compressed Air and Specialty Gases
Type SD
*Measurement to ISO 2533 and DIN 1343*For compressed air in industrial use as well as argon (Ar), carbon dioxide (CO2), nitrogen (N2)*Large measuring range up to 700 Nm³/h*Fast response time and high response sensitivity*With volumetric flow quantity, total quantity and temperature indication
-
product
Integrated Clamp-On Ultrasonic Flowmeter
KATflow 210
The KATflow 210 is a portable flowmeter designed for situations that require a reliable flow measurement regardless of the conditions in which it needs to be operated. With its advanced battery technology and durable waterproof housing the instrument is intended for long-term installation in remote areas where access to power is limited and exposure to the worst of elements is likely.
-
product
Multiphase Flowmeter - Vega Isokinetic Sampling
VIS
VIS is a high-performing yet compact multiphase flowmeter, tailored for wet gas applications and able to provide outstanding accuracy also in the most challenging operating regions.
-
product
Paddlewheel Flow Sensor
2537
The Signet 2537 Flow Sensor is the next generation in fluid measurement technology from the inventor of the original paddlewheel flowmeter. This sensor is an enhancement on what is already an industry standard. It has the added functionality of various output options including flow switch, pulse divider, digital (S3L) or 4 to 20 mA. Additionally, it offers low flow, low power and high resolution and can be configured on-site directly through the built-in user interface.
-
product
Portable Ultrasonic Flowmeter
UFP-20
The Portable Ultrasonic Flowmeter UFP-20, based on the same, ergonomically advanced design so popular in the UFP-10, features significant size reduction. The result is a portable ultrasonic flowmeter that meets next-generation standards.
-
product
Portable Ultrasonic Flowmeter
PORTAFLOW 220/330
The Portaflow range brings simplicity to thenon-invasive measurement of liquid flow. Portaflow offers the user quick and accurate flow measurement with its easy to follow menu and simple set up. Results can be achieved within minutes of opening the case. Compact, rugged and reliable, the Portaflow range has been designed to provide sustained performance in industrial environments.
-
product
Thermal Mass Flowmeters
ABB’s thermal mass flowmeters are suitable for all industrial and test rig applications that demand quick and precise gas measurement. The flowmeters directly indicate the mass flow or normalized volume flow of gases without any additional pressure and temperature compensation. They have an impressively high accuracy, short response time and a very wide flow range with virtually no loss of accuracy even at the lowest flow rates.
-
product
Ultrasonic Energy Meter
Series TUF
The SERIES TUF Ultrasonic Energy Meter is a highly accurate and stable energy meter that utilizes ultrasonic technology to measure heating and cooling energy consumption. The Series TUF is a compact meter with a flowmeter and energy calculator in one, making it great for installation on chillers and boilers.
-
product
Ultrasonic Flowmeter
F5
Gentos Measurement & Control Co.
F5 ultrasonic flowmeter uses the latest digital technology and low-voltage broadband pulse transmission. The instrument can tolerate a small amount of bubbles or suspended solids in most industrial environments.
-
product
Ultrasonic Flowmeter
Portaflow C
The new Fuji Water Flow C uses the same measurement principle as Fuji's ultrasonic flowmeters of which a great number have already been delivered.
-
product
Vortex Flowmeters
The robust design of ABB’s vortex flowmeters provides high performance and reliability in liquid, gas and steam measurements. Equipped with digital signal processing (DSP) and advanced filtering techniques, these innovative flowmeters from ABB allow excellent flow signal detection and provide measurement immunity from the effects of hydraulic noise and pipeline vibration.
-
product
Water Flow / Pressure Measurement
Uses the same measurement principle as Fuji's ultrasonic flowmeters of which a great number have already been delivered.
-
product
High Accuracy Flowmeter
OPTIMASS 1400
Optimass 1400 Flowmeter is a high-accuracy Coriolis mass flowmeter for general ship fuel applications in the marine industry, including fuel mass, density and volume flow measurement (±0.15% of MV) in the harshest conditions on ships.The OPTIMASS 1400 is a cost-effective twin straight tube Coriolis mass flowmeter for a wide range of standard applications with gases and liquids (up to 170,000 kg/h or 6,235 lb/min).
-
product
Spool Piece Ultrasonic Flowmeter
FST
Three pairs of sensors for accuracy of ±0.2% of rate. Using the new algorithm for calculating the flow velocity, it can measure any type of fluid with high accuracy. Low maintenance. With no moving parts, FST has long-term stability while requiring only minimal maintenance work. Bubble resistant. By using the advanced anti-bubble measurement technology, the interference from air bubbles is greatly eliminated. Pipe diameter: 50 mm, 80 mm, 100 mm.
-
product
Advanced Clamp-On Ultrasonic Flowmeter
KATflow 150
The KATflow 150 is the premier product for flexibility and performance, providing the user with a comprehensive specification and a list of configuration options. The practical modular design and the wide variety of different transducer types available ensure this instrument is suitable for everything from simple water flow measurements to energy flow monitoring and automated process control.
-
product
Electromagnetic Flowmeters
Measuring for process management, revenue collection, liquid transportation and energy conservation. Whatever the application, ABB´s intelligent design, state-of-the-art technology and advanced features work harder and smarter to make your operations more efficient and cost effective.ABB offers the most comprehensive range of EMF product lines tailored to your needs.
-
product
Ultra Sonic Flow Meters
RB Flow meter manufactures and Supplies Ultrasonic flow meter, non-intrusive, Clamp-on Ultrasonic flowmeters, insertion ultrasonic flowmeters, handheld flowmeter, heat meter, BTU meter, water meter, portable flowmeters, ultrasonic flowmeter, ultrasonic flow meters, portable flow meter, handheld flow meter, and more.
-
product
Ultrasonic Flowmeter
F8
Gentos Measurement & Control Co.
The F8 Flow meters is a state-of-the-art universal transit-time flow meter for heavy industrial applications. Sophisticated electronics incorporating the latest developments in digital signal processing coupled with powerful ultrasonic transducers deliver highly accurate flow measurement for liquids in full pipes.
-
product
Differential Pressure Flowmeters
From simple orifice plates through to custom-engineered metering systems, ABB's differential pressure (DP) flowmeters measure a variety of fluids including water, air, steam, heavy oil, slurries and molten sulfur.
-
product
Portable or Stationary Ultrasonic Flowmeter for Liquids
DUC
Two ultrasonic clamp-on transducers are externally mounted on a pipe and produce an acoustic path. The transducers send and receive acoustic signals and their transit times are measured by an electronic flow transmitter. The signal is accelerated by the flow in the forward direction. The return signal is decelerated by the flow in the opposite direction. The difference in time between the two, together with the path length L, can be used to determine the average flow velocity. This principle is known as the acoustic time-of-flight principle.
-
product
Fixed Clamp-on Flowmeter
D118
Gentos Measurement & Control Co.
The D118 ultrasonic flowmeter is based on Tansit-time technology, which has ultra-high measurement accuracy. D118 uses an external clipped Transducer, which can collect flow data simply by clamping it on the outside of the pipe, and it will never come into contact with the fluid, and will not cause liquid pollution, pressure reduction, leakage, etc.
-
product
Electromagnetic Flowmeter for conductive liquids
Picomag
Reliable measurement and monitoring of industrial water, cooling water or warm water. Simultaneous measurement of flow and temperature. Flexible integration into all fieldbus systems via IO-Link. Commissioning and operation via Bluetooth® and SmartBlue App. Minimum conductivity ≥20 μS/cm. Fluid temperature –10 to +70 °C (+14 to +158 °F).
-
product
F65/F150
The Porter Models F65 and F150 Forged Body Flowmeters feature a compact, one-piece, black anodized forged aluminum body with wraparound window for full 180° visibility of the flow tube